You should measure the reverse of your doors in millimeters (the industry standard measurement). As a rough guide if your unit is 500mm wide your door will be 496mm wide, if it is 350mm wide your door will be 346mm wide, see it’s always 4mm narrower to allow plenty of room for clearance,
if you think your existing doors are too small or too big for your unit you can always add a little bit to the size but do not exceed the 4mm clearance.

The height of your doors follow the same principle with 5mm clearance. Your base unit doors will probably be in the area of 715mm in height and your wall doors about 570mm to 715 mm but don’t forget we make to your exact specification.

Measure your doors once, then twice then again! Remember the old adage measure twice cut once!

We will drill your doors for hinges with 35mm centres (supplied separately) at 100mm from the bottom of the door and 100mm from the top of the door. please let us know on your order sheet if your door is left handed i.e. drilled for hinges on the left as you look at the closed door on the unit or vice versa for right handed.

Hinges

If you don’t want to reuse your existing hinges we can supply industry standard hinges to make opening and closing your cupboard a pleasure!

These hinges are suitable to 15 and 18mm units and are approved to BS6222 (1997) part 2 level 2 and like our doors are designed to tolerate the rigors of family life.

Don’t forget that if you want to use your existing hinges you need to check they are compatible with our 35mm centred hinge holes.